การประกอบเครื่อง

P2S

P2S, Tool Box, Spool Holder Assembly, Touchscreen, PTFE Tubes, Power cable.

Note: The power cable is located in the top accessory box of the chamber.

ขั้นตอนการเอาเครื่องออกจากกล่อง

แกะกล่องแล้วหยิบคู่มือ

เมื่อเปิดกล่องมาแล้วจะเจอกับคู๋มือ Quick Start Guide ภาษาอังกฤษ แนะนำให้อ่าน หรือสแกน QR code เพื่อดูวิธีการประกอบ

ทำการเอาแผ่นกระดาษออก ท่อ PTFE และ โฟมออก

• Remove the cardboard, take out the PTFE tube, and then remove the top foam.

• Lift out the printer, place it on a stable surface, and remove the moisture-proof bag.

• Remove the tape from the bottom of the side panels.

Failure to remove all tape from the bottom of the side panels may block cooling and affect printer performance.

• Peel off the top tape, remove the glass top cover, and take off the protective bag.

• Peel off the tape on the front and remove the protective bag from the front door.

Step 2 - Take out Accessories

• Take out all accessories and remove the cardboard.
  

Step 3 - Remove Transport Materials

• Use the H2.0 Allen key to remove the 3 screws marked in red.
  

Note: When removing the heated bed fixing screws on the back of the printer, the screws may easily fall into the chassis. We recommend preparing a magnetic screwdriver, tweezers, or similar tools in advance to catch or retrieve the screws and prevent them from dropping into gaps inside the device.

Keep the foam around the heatbed in place until calibration is complete.

• Remove the desiccant and tape inside the printer.

• Pull down and remove the red plastic protectors from both lead screws.

• Cut and remove all zip ties, move the toolhead forward, and remove the foam.

Step 4 - Install the Touchscreen

• Remove the tape, then press the terminals on both sides of the cable and insert it into the screen port.

• Push the flexible cable back into the printer slot. Then, insert the screen and slide it to the left to lock.
  

Step 5 - Install the Spool Holder Assembly

• Slide the spool holder into the base plate until you hear a click.
  
• Insert the PTFE tube holder into the spool holder slot.
  
• Insert the shorter PTFE tube into the tube couplers on the spool holder assembly and the printer.

Reminder: When separating the spool holder, the first operation may be slightly laborious. It is recommended to shake the holder up and down first, then pull it out smoothly.

Step 6 - Power On and Calibrate

• Plug in the power cable and turn on the printer.

• Follow the on-screen instructions to complete the initial calibration.
  

Before calibration, make sure that the build plate is properly placed on the heatbed.

• After calibration, remove the foam under the heatbed.

Step 7 - Place a box or container to catch filament purges which fall from the chute

The small box which filament is shipped in is a great solution to this until a better alternative can be set up. Be sure to place the container below the rectangular purge chute opening at the back of the printer (example on a P1S pictured below).

A more permanent solution may be printed later by searching for an P2S purge container on MakerWorld.

Everything is ready! Please refer to P2S First Print to start your first print.